Symptom:
Unable to push projector defaults from Admin Web page thru ACU to wake up projector
Unable to see projector output from local or remote share.
Conditions:
Projector lost power momentarily, power is then restored returning to an off/standby state (Red LED state for Power).
Additional Details:
Group 100 settings are assumed to be properly configured on projector and ACU is properly connected
http://www.cisco.com/en/US/docs/telepresence/cts_admin/cts_troubleshooting/cts_trbl_presentation.html
Note : The Sanyo PLV-Z700 projector does not require the Group 100 setting. The PLV-Z4,PLV-Z5 and PLV-Z60 all need the manual application of the Group 100 setting when the projector is first installed.
Workaround:
Must manually turn on projector either with remote control or press the on/off button located on projector.
