cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1044
Views
0
Helpful
1
Comments
vraut
Beginner
Beginner

Direct Upgrade Procedure for Cisco Unified Communications Manager Releases 6.1(2)—9.0(1) to 9.1(x)

Introduction

This document provides procedures for performing a direct upgrade to Cisco Unified Communications Manager (Unified Communications Manager) Release 9.1(x) from Releases 6.1(2) through 9.0(1).

About direct upgrades

You cannot upgrade directly to Unified Communications Manager Release 9.1(x) from Releases 6.1(2), 6.1(3), 7.0(1), 7.0(2), and 7.1(2). For these releases, you must perform the upgrade in three stages:

1 Upgrade to Release 6.1(4) or 7.1(3) as an intermediate release.

2 Perform a direct upgrade to Release 9.1(x).

3 Virtualize Release 9.1(x).

The procedures in this document support high availability for all three stages of the upgrade.

This document is applicable to Unified Communications Manager clusters with the following environment:

• Any of the following Unified Communications Manager Releases are installed: 6.1(2) through 9.0(1).

• All of your current Media Convergence Server (MCS) servers support Unified Communications Manager Release 9.1(x).

• No changes are required to the IP addresses or hostnames for the Unified Communications Manager upgrade. If you need to change IP addresses or hostnames, you must do so in a separate maintenance window, prior to the upgrade. For more information, see Changing the IP Address and Hostname for Cisco Unified Communications Manager, Release 9.1(1).

Comments
ogmez
Beginner
Beginner

thanks !!!

thats exactly that i like to find

atte

ogmez

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links