This document was generated from CDN thread
Created by: Thomas Fontaine on 26-06-2009 01:59:26 AM
I am searching for a way to rtp stream audio files to ip phones. These ip phones would have registered to a multicast address through a programmed soft key that uses a service URI indicating the multicast address.
Can I do that with cisco TAPI and UCM in a simple way (using waveOut functions) or is there any resource to help me figure that out ?
Thanks in advance,
Thomas.
Subject: RE: multicast audio to ip phones
Replied by: Shwetha Sanjeev on 10-07-2009 05:42:49 AM
you can use either wavout functions or WinRTP which were used by Cisco soft phones.
Subject: RE: multicast audio to ip phones
Replied by: Thomas Fontaine on 10-07-2009 06:08:25 AM
Thank you.
I opted for winRTP a few days ago and it works well.
waveOut functions are more adpated to direct device management but could work too.
