You can use this checklist to isolate if you are facing any issues with upgrading your device. It contains step by step checks to see that all the things are in place.
I know this is an old post, But thought I would check here first. I have a C40 Codec that will not upgrade. No matter how I try either from the TMS or the WEB interface I get the same failure.
/share/installimage/hooks.d/installimage-endeavor failed to run
We did recently add the Touch panel, and I will have the colleagues remove it once they get on site. But has anyone else seen this??
The release note of CSCud92375 explains your touch panel hardware is too old to work with the newer software on your codec. Can you please take a picture of the labels on the touch panel to check serial number?
Installimage-endeavour failed to run!
Symptom: During upgrading you will see this error message in the console log .
Conditions: The reason this message jump up , is that the software isn't supported to the connected touch device
Workaround: During this time RMA the touch device
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: