We received a problem from a customer that they are unable to initiate a call to Avaya phones from Cisco phone. But from Avaya to cisco is working fine. This client has 3 different locations and in all location cisco is working fine, they can call our extensions and we can call their's(Cisco), but the problem is with the Cisco to Avaya phones only.they can call our extension (From Avaya to Cisco) but we can't call them.This is the issue is happening is intermittently.
We have CUCM 12.X that is connected by a sip trunk to an Avaya System in a remote office. The first location I am controlling and the Avaya system (Another team).The Sip trunk is up and it is showing full service. And the remote office can call the head office but the head office can't call the remote office. and I'm not sure if the problem is from my side or their side. I tried to search a bit about that and nothing seemed to help. and dial-peer is pointing to all of our CUCM servers.This is the issue is happening is intermittently.Whenever this issue is occurred, when we resenting the SIP trunk and then this issue will get fixed.
is there any specific parameter that I should check?
Hello all, I need your help! I have a CUCM 12.5 and a gateway voice ISR 4321 , and i need to configure SRST , for 10 IP phones from 200 IPhones , How can i choose those 10 IP phones to function on SRST mode ? Best regardsAkram
I just received an E1 from a cellular company and I am able to receive calls fine, however, outbound calls are failing due to the screening indicator being incorrect.Can you assist in letting me know how to get this done? *Jan 13 19:40:01.978: //72/0...
Am presently running CER 11.5.1 question we have been adding lots of jabber clients we have a 150 sites with uses id i add the data subnets which is where jabber resides at all our sites and associate each sub-net with an erl for that site when some...