Communities of Interest

Hi, I am getting SSL Connect error while calling POST vManage j_security_check API as per below snapshot.please help me on this how to resolve SSL error.  

Hello, The certificate manager alerting is not working on the CUCM, and we were looking at how to get the contents of all the certificates the CUCM uses (Own_Certs, Trust_Certs) so that we can monitor each of them. I have tried to use paramiko and py...

Hello, Reposted in DEVNET I am trying in the lab this code snippet no good result yet... using python 3.9.1 with requests  https://developer.cisco.com/docs/certificate-management/#!introduction I working on getting logs from RTMT, but I continually g...

Is there going to be any pyATS/Genie models that will support a learning model for 'cable' based commands for learning the HFC/RPHY Cable environments?

Hi Folks, Trying to use WSAPI to gather CDRs from a CUBE. I can get the app registered and it receives CDRs but fails after a time due to an inaccurate ResponseXcdrProbing message my app sends back. I followed the example of the xcc probing response ...

I'm attempting to write a macro for a Room Kit Pro to enable a split screen mode. Everything loads without error but the displays will only show the last ConnectorId listed full screen. Not sure how I've messed this up. Please help me figure out wher...

 Hello Cisco Community, i am working on development of Ansible playbook to automate ACL management on Cisco devices within our network.There are some examples available which would fit for my task, but almost all of them remove an ACL first before ap...

We are having difficulty setting up the API between ServiceNow and WebEx.OAuth2 is requiring the admin user ID and password for the second authentication.Ideally we would like OAuth token created that does not require SSO back to Okta for DevNet.  Is...

Hello,  I am trying to create NSO NETCONF NED with ned builder and I am seeing this error module openconfig-platform-port 2018-01-20 build-error module openconfig-platform-transceiver 2018-11-25 build-error at line 557: the node is config, but refers...

Was waning some help on interpreting the output of the Genie/Pyats diff that I ran on my IOSXE device. I'm not sure how to interpret what all the Indexes refer to. On the surface this looks like there were several "indexes" for the default route (0.0...

Hi, anybody knows how to change vrf name and re-apply the same ipv4 address and ipv6 address.I configure "no ipv4 address" and "no ipv6 address" and change the vrf name, then when I configure the same ipv4 and ipv6 address the result is an error. 

Hello everyone I would like to ask 2 questions:1. I build a workflow and try to extract variables from a table I created by "Read Table From JSON" without success because when I try to access the "source array" of the table it just does not give the...

Hi All,I have a custom application (written in ASP.NET) that is used by a customer service rep to register customer service requests. In this custom application I want to also have a telephony integration functionality to retrieve caller's phone numb...