ā06-22-2015 06:17 PM - edited ā03-15-2019 06:09 AM
Hi experts,
I am facing an issue regarding the outgoing fax. Detail is as under.
- Extension to extension and Fax from the PSTN works fine.
- We are using analog FXO lines as PSTN
- For outgoing FAX doesn't connect. Using analog phone most of the times it gives busy but sometimes call connect towards the pstn.
I have Fax mode T.38 on cucm admin page for ata.
I will be able to share gateway configuration later on.
Need help.
Regards,
ā07-09-2015 01:00 PM
I had the same problem. Inbound started working once dial-peers were configured for each ATA in the GW, but outbound was still an issue.
We finally fixed outbound by changing the Fax mode from T.38 to NSE Fax Pass-through g711ulaw.
Good Luck
ā12-08-2015 04:11 AM
Hello
I have a similar issue but my case is is alarm line where it is just an analog phone .
do you have any idea ?
thanks
ā12-08-2015 08:05 AM
The ATA worked fine as analog line, inbound and outbound worked, but faxing was the issue. They registered with no problem with CUCM 8.5 at the time. what issues are you currently having?
ā12-08-2015 11:25 AM
I am not having an dialtone on ATA 190 .
when I dial incoming it is working .but when I try outgoing nothing is happening .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide