01-13-2010 10:22 PM - edited 03-14-2019 05:06 AM
Hi All,
I have a problem with istalling CAD on Agent PC after finished I start the program and it require to update software
but after updated it still require me to update software again and it loop over and over never complete the update.
Anyone can help me to verify the problem? I used CM7.1.2a and UCCX7.0 SR3
Thanks,
Tinnakorn
01-13-2010 11:21 PM
Out of curiosity, when you run the update, is the user able to install software?
01-14-2010 01:14 AM
I used local Administrator to install/update program.
Tinnakorn
01-14-2010 02:17 AM
Try installing the software as this user, which means you might have to raise the users levels in order to do this task. Once you're able to run CAD without it needing an update then you can lower her rights again.
david
01-14-2010 02:26 AM
Hi david,
I used this user which has an administartor level to install/update but same result.
01-14-2010 07:30 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide