cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
133
Views
0
Helpful
0
Replies

Change rmcm and jtapi providers

dbooth
Beginner
Beginner

After a CUCM IP address change of I have followed the documented procedure here - Cisco Unified Contact Center Express Administration and Operations Guide, Release 11.6(1) - Update Unified CM IP Address Change in Unified CCX [Cisco Unified Contact Center Express] - Cisco and used set uccx provider ip axl/jtapi/rmcm to change the provider IP addresses on the UCCX publisher. However, when I run show uccx provider ip jtapi/rmcm on the UCCX subscriber the change is not entirely reflected. The first line of each output (UCCX JTAPI Provider or UCCX RMCM Provider) still shows the old IP addresses.

Should the output of show uccx provider ip jtapi/rmcm be the same on both UCCX Pub and Sub? If so, how should I go about resolving this please? Thanks.

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers