06-30-2020 06:04 PM
Hello everyone. I hope you are well.
I always use the command Show Proceses on the SystemCLI to check the active services. I know I can check on the Diagnostic Framework Portico, but I prefer the SystemCLI.
My question is about Automated Command Execution using batch files. Is this possible? the serviceability guide for the version 11.5(1), says that We can use it. The guide does not say, specifically, where should We run the batch file
Im not sure, because all the documentation says that is only for CVP.
Could you help? if you have an example it works for me.
07-01-2020 05:55 AM
Is this what you're referring to? I've not used it myself but it looks like it is for CVP and non-CVP devices?
07-01-2020 08:18 AM
Bill, thank you for your reply.
im referring about the
CLI or System CLI commands can be executed automatically using the following mechanism:
I would like make automatic the command show processes to check the worker side in the UCCE.
07-01-2020 07:21 AM
Is there something the portico doesn't give you that the CLI does? Your best bet is to use the portico API if possible.
david
07-01-2020 08:22 AM
David, thank you for your reply. you are so kind.
no, but We can check more things on the SystemCLI about UCCE.Do you know how create the .bat for request on the SystemCLI?
07-03-2020 10:36 AM
Any suggestions?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide