Hi All,
I am using an asr 1006 (RP2) as a cube router. I want to set up applications (for ccb) via dial-peers but dont think its fully supported (see below article... it's a bit vague though):
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cust_contact/contact_center/customer_voice_portal/srnd/9_0/CCVP_BK_C7053373_00_cvp-9-01-srnd/CCVP_BK_C7053373_00_cvp-srnd_chapter_0111.pdf
I was wondering about the following 2 things:
1. Is it possible to configure an asr 1006 (RP2) as a vxml router to support this and
2. If its not possible, is it possible to just set up a dialpeer to another router and just set up the other router to support ccb?
Thanks!
