Controllers

Hi, Last December I heard that Cisco is going to release APIC-EM with PnP module only, is there any update on that?as an extra, is there going to be any support for ASR900, 920 and ME1200?

I am using the EZQoS function and have noticed that multilink interfaces tagged with the correct service provider description it does not have any service output policy applied. Is this normal, does apic-em EZQoS support multilink interfaces? Thanks ...

Ok so I have a two instance environment where the router at our warehouse will get the base config from the first APIC-EM instance at router power up.  This config will be the bare basics of being able to reach the second APIC-EM instance in our Data...

Hi ,I am trying to install APIC-EM(1.6 and 1.3) in vsphere. In both the cases i am getting fallowing error.Could any one suggest how to overcome this error.

Hi,I'd like to know all possible "failureReason" of "get /task/{taskId} " for below tasks so that we can program automatic error handling for each "failureReason".The task to track is;delete /pnp-project/{projectId}/device/{deviceId}post /pnp-project...

Hello Everyone,I have been trying out the Sandbox APIC-EM MiniLab-1 for the past 2 days , I can access the APIC-EM web gui/SSH just  fine, but Device Discovery failed, I then try to SSH to some of the lab devices, also failed.  Configured the SNMP / ...

Helllo,For devices that were discovered, can I delete those devices without any adverse affect on those devices? I ask this because with a device that was provisioned, when I delete it from the Network Plug-n-Play area, APIC will go out to that devic...

I always get an error on the status but apic em pushes the device. I get the following error message but the config is pushed to the device. Any ideas?Received response from pnp agent for message correlatorId: CiscoPnP-1.0-17-494-3A341458-17 but with...

Hi,has anyone seen this error before? PnP is unable to push the configuration to a device c.c.e.p.s.u.ZtdServiceConversionUtils | PnpZtdServiceAdapter.getOneTimeDownloadUrl() Failed to create download URL for fileIdcom.cisco.grapevine.amqp.exception....

I am not seeing any API's to edit the config's on the devices, routers or switches etc.  Are those just not exposed?ThanksMike

Hi,We currently use PI3.1 and CNS to bootstrap and provision devices by creating a generic PnP Profile without a serial number.This works really well and we are able to zero touch provision around 20-30 devices per week (800 series, ISR G2, ISR4K, CA...

Hi,There is around 80 vlans created on Nexus 7000. I fetch those vlans using API request through APIC-EM. I only reach 76 of them. The ones I don't reach are: 6, 66, 122 and 123. I'm talking about vlans, not interface vlans.Did someone had similar is...