(Bit of a newbie when it comes to 1000V. Apologies in advance if I'm using the wrong terminology.)
I have two separate 1000V environments and both worked perfectly up until a few days ago. Now, however, one of them has stopping syncing up with vCenter. That is, if I do this...
# config t
# port-profile type vethernet Test
# vmware port-group
# switchport mode access
# switchport access vlan 1
# no shutdown
# state enabled
# end
...the port group never shows up in vCenter. (Previously, it appeared as soon as I entered "state enabled".)
If I do...
# show svs connections
...I see the correct vCenter IP address, with config status "Enabled", operational status "Connected" and sync status "Complete".
Can anyone offer some troubleshooting suggestions so that I can get back on track? Naturally, I have new customers eager to get up and running who are stuck without connectivity at this point.