cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
142
Views
0
Helpful
1
Replies
Participant

L3 Port-Channel To NX7K vPC Domain

Hello, 

 

 

 

We are considering changing the current vPC configuration of our access-layer switches from L2 to L3. They are currently attached to single-sided vPC domain via L2 Port-channel.

 

 

According to the below Cisco document, NX7K doesn't support attaching a end-device to a vPC domain using L3 port-channel. Does NX7K support L3 port-channel?

 

 

 

Page 38of 129

Page 46of 129

 

https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/sw/design/vpc_design/vpc_best_practices_design_guide.pdf

 

Thanks in advance, 

~zK 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Participant

Re: L3 Port-Channel To NX7K vPC Domain

I think I found the answer. Yes, L3 over vPC is supported on the NX7K depending on the module model and sw code installed on the vPC peers. Here's the Cisco document: 

Everyone's tags (1)
1 REPLY 1
Participant

Re: L3 Port-Channel To NX7K vPC Domain

I think I found the answer. Yes, L3 over vPC is supported on the NX7K depending on the module model and sw code installed on the vPC peers. Here's the Cisco document: 

Everyone's tags (1)
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards