i have confiugred two pair of OTV in my nexus devices DC1 and DC2 .
DC1 = two devices
DC2= two devices ..
i could see the three adjanceny in every otv device.
but show otv site is showing partial .. site vlan is properly configured .still the partial not chanhg===
site vlan 99
otv extended vlan 100:
DC1-7K1# show otv site
Dual Adjacency State Description Full - Both site and overlay adjacency up Partial - Either site/overlay adjacency down Down - Both adjacencies are down (Neighbor is down/unreachable) (!) - Site-ID mismatch detected
Local Edge Device Information: Hostname DC1-7K1 System-ID 5000.0001.002f Site-Identifier 0000.0000.0111 Site-VLAN 99 State is Up
Site Information for Overlay1:
Local device is AED-Capable Neighbor Edge Devices in Site: 1
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...
Hi allWe're trying to tackle a DHCP relay problem between a set of N9K-C9332PQ (NXOS 9.3.2) and dnsmasq (doesn't work) resp Windows 2016 DHCP service (works with some tweaking).SITUATION:We have a BGP EVPN VXLAN (L2VNI and L3VNI) with anycast gateway setu...