Joined a pair of 92K switches in a VPC domain. I receive the following below. Anyone know what may be wrong as I checked both switches and everything looks the same?
Configuration inconsistency reason: vPC type-1 configuration incompatible - STP
vPC domain id : 10
Peer status : peer adjacency formed ok
vPC keep-alive status : peer is alive
Configuration consistency status : failed
Per-vlan consistency status : success
Configuration inconsistency reason: vPC type-1 configuration incompatible - STP
global port type inconsistent
Type-2 inconsistency reason : Consistency Check Not Performed
vPC role : secondary
Number of vPCs configured : 0
Peer Gateway : Enabled
Dual-active excluded VLANs : 252
Graceful Consistency Check : Enabled
Auto-recovery status : Enabled, timer is off.(timeout = 360s)
Delay-restore status : Timer is off.(timeout = 150s)
Delay-restore SVI status : Timer is off.(timeout = 10s)
Operational Layer3 Peer-router : Disabled
So I notice on show consistency vpc global... I got the following on one switch but I don't see what is different between them to change them both to normal. ANy help??
STP Port Type, Edge 1 Network, Enabled, Normal, Disabled,
Name Type Local Value Peer Value
------------- ---- ---------------------- -----------------------
STP MST Simulate PVST 1 Enabled Enabled
STP Port Type, Edge 1 Network, Enabled, Normal, Disabled,
BPDUFilter, Edge BPDUGuard Disabled Disabled
STP MST Region Name 1 "" ""
STP Disabled 1 None None
STP Mode 1 Rapid-PVST Rapid-PVST
STP Bridge Assurance 1 Enabled Enabled
STP Loopguard 1 Disabled Disabled
STP MST Region Instance to 1
