How to connect an extended node with another extended in sd access

[Ciro G Mele]

Hi,

We always connect an extended node  with a fiab but you can connect an extended with another extended in sd access ?

Thanks in advance.

Ciro Gustavo Mele

[balaji.bandi]

yes that is possible daisy chain - depends on what DNAC version you using :

[Ciro G Mele]

Hi,

Dnac version 2.2.3.7, the equipment being used for the 2 extended nodes is a Cisco Catalyst 3560, It is possible to carry out this configuration with the 2 Cisco devices..?

Thanks in advance.

Regards.

Ciro Gustavo Mele.

[Andreas29]

Hi BB, can you name the Cisco Live session your showed picture refers to? Kinds Andreas

[Ciro G Mele]

Hi,

I ask you a question: can an extended node be connected against another extended, we never carry out this type of configuration, only towards a fiab, can it be done?

Thanks a lot.

Ciro Gustavo Mele.

[jedolphi]

Chain of C9K or IE Extended Nodes is supported. HOWEVER, when we added support for EX chain, 3560-CX was EOS (End of Sale), thus it's not supported to chain 3560-CX Extended Nodes. When we add feature support to SDA, we test the feature internally against a range of combinations and situations. Generally speaking the testing methodology only tests current switches, not EOS switches, I hope it's clear why this is the case: testing all legacy switches (4500, 3560, 3850, etc.) for new capabilities significantly decreases the feature velocity, and if issues are found they cannot be fixed because the EOS switch O/S is in maintenance mode. Regards, Jerome