02-27-2021 12:58 PM
Hello Community
I'm following the doc
we have 3 interfaces for the virtual appliance. During configuration, we have import, we configured 3 interfaces - MGMT, DATA1 and DATA2
When we configure the interface config for each interface. We lose UI connectivity as we commit.
In reading the guide, do we have to set gateways for each interface, then set routes for traffic?? The guide is unclear on how to proceed with that
Is there a guide that someone can share for end-to-end configuration of ESA's?
Thanks everyone
02-27-2021 01:07 PM
Make sure you configure the mgmt interface first and start managing using mgmt interface IP. - mgmt route set to mgmt network gateway.
02-27-2021 01:17 PM
Hi Balaji
Thanks for the quick reply.
When you say mgmt route ?? - does this mean using the route? or the setgateway ???
Thanks
02-27-2021 01:20 PM
Take example :
1. configure mgmt interface 10.10.10.1 gateway 10.10.10.254
2. your Device you using GUI to configure able to reach the 10.10.10.X network before you do any other changes.
is this make sense?
02-27-2021 01:43 PM
Hi Balaji
does gateway have to be set for all the 3 interfaces?? MGMT, DATA1 and DATA2
They are all on different subnets
Thanks again Balaji
02-27-2021 01:46 PM
yes, they need to have a respected gateway each one to communicated to pass the traffic.
i assume since you losing the GUI, due to gateway overrides with mgmt or routing.
02-27-2021 01:48 PM
Thank you very much @balaji.bandi
02-27-2021 03:06 PM
I think thats the main issue. When I use cli - setgateway. It only accepts one gateway.
I can't find any other way to set gateway on other interfaces - is there any documentation on how to do this??
Thanks
02-27-2021 03:11 PM
It only accepts 1 Gateway, you need to add static routes for the respected interface example
Data1 :
IP address 10.20.20.2 255.255.255.0 gateway is 10.20.20.254 ( it should route towards 10.20.20..254)
then add static route 10.20.20.0/24 network towards 10.20.20.254.
Make sense?
02-27-2021 03:14 PM
HI
ok. that's what I was afraid of.
have to configure around 15 routes then
Thanks Balaji
02-27-2021 03:17 PM
Not sure why 15 routes, if you have that much route requirement, you need to do it to work as expected.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide