7965 Display Error - Port Configuration Error

[Jason Lee]

Community,

I have a customer who is experiencing what appears to be a cosmetic error on their 7965s.  When deploying endpoints into the field they have found that if they hard code the speed/duplex to 100/Full on the PC port of the phone they get a "Port Configuration Error".  The funny thing is that the PC appears to function normally at 100 Full.  When I change the endpoint to auto-negotiate from CUCM the error goes away. 

Has anyone ever run into this?

Endpoint:     7965

Protocol:     SIP

Load:          SIP45.9-3-1SR2-1S

[tonyperla]

What is the switch port set to?

[Jason Lee]

I'm not sure.  The guys working on the network portion of the install have departed.  The issue I'm running into is on the PC port of the phone connected to a daisy-chained PC.  

[tonyperla]

No worries, how about the actual switch port on the phone?  Are both the PC and SW ports set to Auto or 100 Full?  I would still be curious about what the network port on the switch is set to as well.  I am running 7965G's in both SCCP and SIP form and no matter how I have the ports set and cannot recreate.  I am also running 9.3.1sr2 firmware on both.