Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HiCisco Documentation mentions that Cisco Unified CME provides a personal address book beginning with version 8.xHowever, there is no clear documentation on how to access and update this personal address book. Has anyone tried this.Also, how many Per...
Hello,I wonder if someone has a working ISDN2 (basic-net3) config they can share for point to multipoint (ideally in the UK).I have always had ISDN2 circuits presented as point to point with a single BRI circuit (2 channels, one physical presentation...
Dear,can anyone help me with the below:i need the specs of CP-PWR-DC7925G-CE (Voltage and Amps)thanks
Does anyone know if the cisco IP phone 7940 support the following codecsG.711A-lawG.711µ-lawG.723.1G.729A.
Hi,Hope someone can help me on this. Below are the CME and CUE versions as well as the FW load of the SIP3911> CME - version 8.6> CUE - version 8.6.3> SIP3911 - FW Load SIP3951.8-1-2SR1Issue: Whenever an incoming call goes through the Auto-Attendan...
Hi All,please help me on how to change E1 signaling type to CCS7 on cucm 9.1best regardskennedy
Hello, everybody!I have a very annoying situation.I have CME with VG-224 connected ovet SCCP. and about 10 analog phones.in the "telephony-service" section I have "transfer-system full-consult" statement.but it does not work as full-consult!this is t...
Been reading over this and seems simple enough.However my query is - during my night time hours - instead of the call going straight to Voicemail, can I let it ring first for say 5 rings, then go to VM during night service hours?During the day, the p...
Hello everybody,Customer have Cisco 2821 witch IOS 15.1.4 and CME 8.6. I set up call forwarding on internal line "A" to external number "B" .When someone from number "C" calls to line "A" this call is forwarded correctly to "B", but the caller ID is ...
Hi,I have setup MVA correctly on one site, after a few months, the call just comes into the voice gateway and then it drops, I have already setup the following:1- Media Resources --> Mobile voice access number2- Service parameters --> Mobile voice ac...
Hello,I had a phone configured in CUCM and it is registered. Then I did factory reset on my phone and that was working well for a while. Now, my phone suddenly shows ''REGISTRATION REJECTED''. Also, I checked the DNs and all those stuffs and everythi...
Community,I have a customer who is experiencing what appears to be a cosmetic error on their 7965s. When deploying endpoints into the field they have found that if they hard code the speed/duplex to 100/Full on the PC port of the phone they get a "P...
HiIn a Unity Connection cluster environment, I have some sporadic reports from end users, that they cannot access their VM, it says "Invalid password", it doesn't happen to all the users in the same timeframe. In the syslogs I can see %UC_IMS-6-cred...
Hi Team,I have a customer who mentioned they had below scenario working but now stopped working. I don’t believe I’ve seen this feature and wanted to check if someone heard about it ??Scenario:- User A calls user B (both have Cisco 7945 phones)- Use...
Hi Folks,We have activated the QRT softkey on a lot of our CIsco IP phones for users to be able to report a call quality issue. Can someone advise how we can view the actual results of users pressing QRT i.e where is the data logged to?We have tried ...
