02-05-2013 02:29 AM - edited 03-16-2019 03:32 PM
Hello,
I am currently experiencing issues while attempting place phone calls from a 9951 that is registered to CME. The ability to dial/call is intermittent. It does not matter how I attempt to dial (e.g. from directory or manual) it sometimes works and sometimes does not. Whenever I attempt to call, I get the following message on CME:
imageattr parse payload numtok not found imageattr payload found, specific is 255
I am currently running CME 8.8 on a 2951 w/ IOS 15.2 (4) M2, and 9951's running on 9.2.2.
Any help would be greatly appreciated.
02-05-2013 07:15 AM
Could be CSCtr33108 .
Move to IOS 15.2(2)T and use the latest firmware for 9951.
Hope this Helps!
Regards,
Karthik
10-09-2013 04:08 PM
Did you find out what the problem is to this? I see the same errors on my CUBE but I'm running UCM with SIP Trunks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide