07-13-2011 09:53 AM - edited 03-16-2019 05:56 AM
Hello I have doubt how can I configure in AA TCLwith Gateway to call at option 4 and also I need to call to extension in range 4…, my problem is the whe to press 4 always to translate to 4119 never I can to calls a other extensions 4…
application
service autoatt flash:its-CISCO.2.0.2.0.tcl
I have a num-exp 4 4119
dial-peer voice 11 voip
destination-pattern 4…
voice-class codec 1
voice-class h323 10
session target ipv4:10.79.15.11
dtmf-relay h245-alphanumeric
no vad
Solved! Go to Solution.
07-13-2011 02:21 PM
No, not really. Just avoid using option 4.
07-13-2011 01:56 PM
You cannot have options overlapping extensions.
07-13-2011 02:11 PM
Thanks Paolo do you know if I can to do anything with 4# for example?To do differs?
That when I press option 4 says to edn press #, then send the gateway 4# to dial-peer is possible?
07-13-2011 02:21 PM
No, not really. Just avoid using option 4.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: