Solved: Add Cell Phone to Cisco ISR 2911

Marcel Belisle · ‎09-25-2014

I would like to know if it is possible for me to get an interface for my ISR router that would allow me to connect a cell phone. Reason been I would like to make some configuration to route my VoIP users through a cell phone whenever they are making calls to a Cellular phone.

I have a Cisco 2911 and also running CUCM 10.5 server. Please help.

Carlo Poggiarelli · ‎09-26-2014

Hi.

Unfortunately no gsm modue for voice is available, data only.

There are a lot of gsm gateway which can talk SIP or H323 with CUCM/CUCME and they are external boxes.

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"

View solution in original post

Carlo Poggiarelli · ‎09-26-2014

Hi.

I don't think it's possible but there are many GSM gateway event with low price to achieve this.

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"

Marcel Belisle · ‎09-26-2014

would you know if this exist as a network module that can be added on to a Cisco router or is it a separate appliance.

Carlo Poggiarelli · ‎09-26-2014

Hi.

Unfortunately no gsm modue for voice is available, data only.

There are a lot of gsm gateway which can talk SIP or H323 with CUCM/CUCME and they are external boxes.

HTH

Regards

Carlo

Please rate all helpful posts "The more you help the more you learn"

Dennis Mink · ‎10-01-2014

If it is least cost call routing you are after, you will need to deploy a GSM gateway, which is configured as a SIP trunk from a CUCM point of view. it contains a bunch of SIM cards and has an external antenna, these guys make it: http://www.topex.ro/

Please remember to rate useful posts, by clicking on the stars below.