03-25-2010 07:03 AM - edited 03-15-2019 09:57 PM
I have 3 ATAs that will not even connect to the network. They came from other locations and I do not know how to get into them to change IP address, etc. The red light is flashing but I am not getting any link lights.
03-25-2010 08:27 AM
If you do not know what settings are on the ATA's your best bet is probably to use the built in IVRto change/test the IP settings.
Follow the procedures at the link below.
http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800c3a50.shtml#task3
03-25-2010 10:54 AM
I tried that but I don't get dial tone. All I can hear is clicking.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
