cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
441
Views
0
Helpful
2
Replies

ATA 186 - How to disable pre-call services

uldericonucci
Level 1
Level 1

I'm not able to contact extension *XXX (ex. *123) using an analog phone connected to ATA 186 with SCCP firmware.

The digit "*" is considered special because is used to activate pre-call services (ex. **1 to call forward all).

It's possible to disable pre-call services, or to choose another digit instead of the "*" ?

Migrate the ATA to H323 could be a workaround?

Many thanks,

Ulderico

1 Accepted Solution

Accepted Solutions

hadbou
Level 5
Level 5

A subsribed service enable/disabled by the user can

# be disabled/enabled dynamically on a per call basis;

#

# Possible values:

# bit 0 (mask 0x1): FORWARD_ALL -- forward unconditional

# bit 1 (mask 0x2): FORWARD_BUSY --forward on busy

# bit 2 (mask 0x4): FORWARD_NOANS -- forward on no answer

# bit 3 (mask 0x8): CLIP_CLIR -- CLIP

# bit 4 (mask 0x10): CALL_WAITING -- call waiting

# bit 5 (mask 0x20): 3WAY_CALLING -- 3-way calling

# bit 6 (mask 0x40): XFER_BLIND -- blind transfer

# bit 7 (mask 0x80): XFER_CONSULT -- consult transfer

# bit 8 (mask 0x100): CALLERID -- caller ID

# bit 9 (mask 0x200): Call Return

# bit 10 (mask 0x400): MWI -- message waiting indication

# bit 15 (mask 0x8000):FAXMODE -- FAX mode

This URL should also help you:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/atasip/sipagch3.htm#xtocid0

View solution in original post

2 Replies 2

hadbou
Level 5
Level 5

A subsribed service enable/disabled by the user can

# be disabled/enabled dynamically on a per call basis;

#

# Possible values:

# bit 0 (mask 0x1): FORWARD_ALL -- forward unconditional

# bit 1 (mask 0x2): FORWARD_BUSY --forward on busy

# bit 2 (mask 0x4): FORWARD_NOANS -- forward on no answer

# bit 3 (mask 0x8): CLIP_CLIR -- CLIP

# bit 4 (mask 0x10): CALL_WAITING -- call waiting

# bit 5 (mask 0x20): 3WAY_CALLING -- 3-way calling

# bit 6 (mask 0x40): XFER_BLIND -- blind transfer

# bit 7 (mask 0x80): XFER_CONSULT -- consult transfer

# bit 8 (mask 0x100): CALLERID -- caller ID

# bit 9 (mask 0x200): Call Return

# bit 10 (mask 0x400): MWI -- message waiting indication

# bit 15 (mask 0x8000):FAXMODE -- FAX mode

This URL should also help you:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/atasip/sipagch3.htm#xtocid0

Excellent!! Thank you very much!