Auto-Provision CP-8861

[ger-lynch1]

Hello,

I have a Cisco CP-8861 phone ad I am wondering how to auto-provision it.

I am using a SIP setup so I must change the firmware to suit.

I know it has to be done through TFTP, The web UI is only used to display information as far as i can tell. 

Is there any provisioning guide to show the steps how to do this, or even better if there were any generic config files that I can use as a template?

[Jaime Valencia]

You should start by saying what you use for call control, and what version, you're using.

[ger-lynch1]

Asterix, and version of what?

[Wilson Samuel]

Hi,

Although few people use Asterix over here, however this is a Cisco forum and most of the people are only familiar with Cisco products, hence I believe it will be much easier if you posted this query on Asterix support platform.

Regards

[Leo Laohoo]

Define "auto provision".

[elisa]

ger-lynch1,

Hi, I have the exactly same the same issue, have you find any solution? Please let us know,Thanks