I have a problem with the billing when I turn on Remote Destination Profile.
I have to set on the CUCM configuration in section Gateway - Gateway Call Routing Information - Outbound Calls - Calling Party Selection "Last Redirect Number (External) because of the accounting with the SP.
If I use "originate" I get no information adjusting who initiated the call for billing. Without this setting the destination of RDP can't see the originate caller number.
Does anyone have an idea how I can use RDP and displaying of the original caller ID and to give the initiated information to the SP over ISDN.
Would you mind to clarify the reason why < " use originate" I get no information adjusting who initiated the call for billing">? Which number your SP checks for billing purpose(calling/called/redirect) ?
I understand that if you set up 'last redirect number' on GW then remote destination will show 0319102817. It is because call manager did a redirect to your remote destination when you are using single number reach.
My question next would be why can't you set up 'Originator' on GW instead of 'last redirect number' ? What is your service provider's requirement?