Hello,
Looking for a quicker way to do the following:
This week we will have to pigrate 350 IP Phones from a CUCM cluster (to be dismissed) to another.
In order for the phones to register onto the new cluster.
We have to reset the security settings (see below).
The only option we have so far is to manuaaly do this on each device. Will take the whole WE...
I was hoping to find a way to do it via the CUCM interface, but I did not find any option.
Any suggestion ?
We are running CUCM 11.5
Thanks
Accepted Solutions
IF you are migrating to a new Cluster you can make use any of the below options.
- "Prepare Cluster for Rollback to Pre-8.0" Set to true then restart the phones.
- Bulk Certificate Management Between CUCM Clusters for Phone Migration
- Use third party to remove the ITL/CTL from phone.
Try UnifiedFx phone view free trial to remove the ITL/CTL. it includes 500 devices.
https://www.unifiedfx.com/products/unifiedfx-phoneview
IF you are migrating to a new Cluster you can make use any of the below options.
- "Prepare Cluster for Rollback to Pre-8.0" Set to true then restart the phones.
- Bulk Certificate Management Between CUCM Clusters for Phone Migration
- Use third party to remove the ITL/CTL from phone.
Try UnifiedFx phone view free trial to remove the ITL/CTL. it includes 500 devices.
https://www.unifiedfx.com/products/unifiedfx-phoneview
