07-08-2016 03:24 PM - edited 03-17-2019 07:28 AM
Created a VG202 gateway to accommodate overhead paging with Broden TAMB2 access module. Configured the DN "#92", endpoint in call manager. Everything is as instructed, but when I dial the DN to access the paging system all I get is a busy signal. Anyone got any thoughts.
Greg
07-09-2016 12:43 AM
Off topic in SMB / ATAs, Gateways and Accessories. VG202 is not a SMB kind of product. Moved to more appropriate community.
07-09-2016 06:02 AM
What protocol between CUCM and the FXS port? If MGCP/SCCP is the port registered? If H.323/SIP, what do the traces look like for the call on the VG202?
07-11-2016 09:57 AM
MGCP, port is not registered. How do I trace on a VG202XM?
New to this type of setup.
Greg
07-11-2016 10:05 AM
Hi Greg,
Use "show mgcp endpoint", for more reference below.
http://docwiki.cisco.com/wiki/Cisco_IOS_Voice_Troubleshooting_and_Monitoring_--_MGCP_Testing_Commands#show_mgcp_endpoint
HTH
JB
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide