Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear I am having issue on CME incoming calls from PSTN line . When calls is coming from pstn it's stuck up and busy tone Kindly assist me to resolve the issue
We use 0 dial out and ever since we have migrated to sip trunk we get full e.164 DID on all inbound calls. Which means we receive +1<10 digits> Problem we are having is on call back so if we have a missed call, we need to do edit dial and get rid of ...
Can I forward all calls to a cell phone? If so how.
I'd like to confirm whether or not the VG350 supports configuration of on-board PVDMs as MTP, XCode, etc. resources. The table below indicates that this is not supported on the VG350 in v15.4(3)M. Is this an IOS version specific limitation or a platf...
Good day everyone, I have an implementation of SIP trunks, but I have a question and doubt about the correct configuration that may be set up. The scenario is: SIP Provider --> CUBE --> CUCM --> DID End users. Basically my question is that if a S...
Can I forward all calls to a cell phone? If so how.
Good Day Team, Please is there a way to force a particular DN to use a particular E1 channel for outgoing and incoming calls. Example Extension 232 translated to (4603363) to push and receive calls using channel 3 only Extension 233 translated to (...
I'm currently using Unity Connection 10.5.1 and using LDAP sync. Everything is working fine but there's on little quirk that's been bugging me for some time now. I've got nearly 400 users but for some reason when it comes time to create new users i...
When I try to configure IM and Presence server , the server give this error. I configured dns server;im and presence server name and ip.
Hi Gooday , I am Mohamed i would like to ask any one can help for my issue regarding the CME Incoming Calls from PSTN Network. i have 8 PSTN Line, all with international Facility, when i get any calls from outside its ringing but if no answer the Rec...
I have a valid CCNA R&S, can I go for CIPT-1 directly or do I need to have a CCNA Voice/Collaboration first?
Working with CUCM 11.5 in my lab to document some processes. I have set up auto registration on many older versions of CUCM, but haven't done it with newer versions. Pulled the systems guide, and followed the directions. No problem. My 7945 (SC...
A call from a Cisco phone to a 4-digit ext on the Siemens PB reach the phone, but on the display only the 4-digit number is visible and not the Calling Party name. outgoing calls from Siemens PBX towards Cisco VG on the E1 link and within the trace i...
We are going to upgrade CUCM from 9.1 to 10.5.2 version. As per compatibility matrix ios of the CUBE is 15.3&15.4.But i am not able to see the ios version for VG224 analog gateway. Anybody please guide me with the corresponding ios.support for CUCM 1...
Hi, I'm working on a cluster of CUCM7.1 and using CISCO IP Communicator 7.0.1 Recently a CUCM sub was and still down, since then all the CISCO IP Comunicators can't register showing the error message: "Registration Rejected: security Error", I've...
