01-04-2008 06:43 AM - edited 03-15-2019 08:02 AM
Hi,
I have two 4 port FXO cards and I have already configured separate IP Phones to make outbound calls through separate FXO ports. But I cannot configure more than one IP Phone to make outbound calls through a partcular FXO port. E.g I want IP Phones with ext. 1023 and 1001 to make outbound calls only through FXO port 3/2 only. I also want only one IP Phone to be able to make calls through several ports. E.g. I want IP Phone with ext. 1016 to be able to make outbound calls throught FXO ports 2/0, 2/1, 2/2, and 2/3 only. Attached is my "sh run" config. pls help
01-04-2008 09:18 AM
Hi,
use trunkunk group for this:
voice-port x/y
trunk-group pots
dial-peer voice 101 pots
destination-pattern 9T
trunkgroup pots
You can also have mutliple trunkgroup under one DP, and select different preferences and hunt schemes for ports comprising the trunk group.
Hope this helps, please rate post if it does!
01-04-2008 01:16 PM
I am not convinced this solves his problem 100% because he also wants to limit specific phones so they can only use specific dial-peers, this needs COR or partitions in addition to the trunk config
01-07-2008 04:21 AM
Hi,
I have tried the trunk config and it still does not sovle my problem. Please what necessary configs do I need for the COR or partitions.
01-07-2008 04:41 AM
As suggested above, trunk-group only groups multiplke lines under a single DP.
Then, are you willing to do a translation rule on CCM for a certain partition, so there is not need to use "answer-address" and prefix on the router ?
Or do you prefer that all the config is in the GW ?
01-07-2008 04:56 AM
Presently I have more of my configs done on the router, I would prefer if the config is done on the router, but would also like to know the implications of having them on the CCM.
Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide