cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
134
Views
0
Helpful
2
Replies
shantanu871
Beginner

CCNA voice

I dont understand the difference between POTS digit manipulation in CME and Route pattern for CUCM

2 REPLIES 2
Jaime Valencia
Hall of Fame Cisco Employee

At some level they're the same, you use them to route calls outbound, the main difference that comes in mind is that a POTS DP will discard exact matches while route patterns won't, and there's a different way to discard digits.

RPs can also add/remove digits in the same page/config, while DPs require translation-rules or some other configuration in the IOS.

HTH

java

if this helps, please rate
Francisco Granados
Participant

I think Java explained it very well, I will add a note taking it wayyyyy basic:

 

- POTS dial peers are part of IOS and can be used to route calls for CME/CUCM to specific devices, like a PRI or a fax machine directly attached to the router.

 

-Route patterns on the other hand can route directly to a device (as long as it's not part of a route list) like a gateway or a trunk, or,  they can route through a route list which can then serve multiple devices in a route group.

 

Thanks,

 

Frank

Content for Community-Ad

Spotlight Awards 2021