Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,
Thank you in advanced for reading. Like the title says, I am looking for input on the most important events to monitor via SNMP. The CVPLogMessages.xml has over 700 events and I want to narrow it down.
I've a few in mind but would love to hear...
All, I am doing a core switch refresh, going from a 3750X stack to a pair of N3ks. A few details:I plan on leaving the stack as L2 access layer for PC clients. I am migrating the Blade Center and SAN to the Nexus 3Ks, hoping to use vPC.The blade cent...
Hi All, Route/Switch is not my bread and butter so I am looking for ideas and advice on how to proceed with a refresh. I am refreshing our core from a stack of 3750-Xs to a pair of Nexus 3ks. L3 is done at the core switch, so I am planning on the swi...
All, Thank you in advance for taking the time to read. Security is not my strength and I need to know if this is even possible. I am migrating to a new ISP and New FWs, I setup the new link and firewalls parallel. I already have the new ISP and new F...
All, I'm looking for suggestions to replace an ASA 5520 that is currently acting as our main DC Firewall. My concern is that we currently do not have any sort of malware protection, no IPS features, and realistically our ASA is mainly a device we use...
For anyone still interested. SIP CME auto registration is now available on CME 11.5, IOS 15.6(3). Extension assigner is also available on 11.6 / 15.6(3)M1.
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cm...
+5 Jaimie
Just as a side note, whenever you use the Self Provisioning IVR with a phone that already has a DN (Auto Reg DN or any other), the new DN will replace the old DN, AND, the old DN will also be deleted from CUCM.
This is fine when using auto...
There is a "Collaboration Sizing Tool" that is available for Cisco Partners/employees, it allows you to size up new deployments but I am not sure it's available to end users.
Maybe someone else can chime in?
-FG
You are correct on the DSP resource configuration. Keep in mind that CFBXXX will only be used if it is assigned to a MGRL/MRG of a phone or device pool.
As far as a config, I can upload one a bit later. In the meantime I will post some of the key ele...
You are correct. +5
Desma,
Your current SIP trunks are not physical lines, they are "virtual channels" inside that 100mb link. If you disconnect the 100mb link, you will lose your SIP trunks. However, your SIP provider can still make the SIP trunk w...
