Hi Again Cisco techs,
Following Jaime Valencias suggestion to upgrade my CME for SIP. Looked at the CME and IOS matrix
CME 7.1 is chosen one and is 41mb basic
My external CF1 slot0 appears to have died as the LED for this no longer luminates with compact flash inside
Troubleshooting proves below
cme_router#sh file system
File Systems:
Size(b) Free(b) Type Flags Prefixes
- - opaque rw archive:
- - opaque rw system:
57336 48655 nvram rw nvram:
- - opaque rw null:
- - network rw tftp:
* 32047100 397360 flash rw flash:
- - flash rw slot0:
- - opaque wo syslog:
- - opaque rw xmodem:
- - opaque rw ymodem:
- - network rw rcp:
- - network rw pram:
- - network rw ftp:
- - network rw http:
- - network rw scp:
- - network rw https:
- - opaque ro cns:
With slot0 empty (no compact flash inside)
cme_router#format slot0:
Format operation may take a while. Continue? [confirm]
Format operation will destroy all data in "slot0:". Continue? [confirm]
Enter volume ID (up to 64 chars)[default slot0]:
%Error formatting slot0 (No device available)
cme_router#
Containing compact flash is the same
And show inventory output
cme_router#sh inventory
NAME: "2691 chassis", DESCR: "2691 chassis"
PID: , VID: 0.1, SN: JMX0642L246
NAME: "Wan Interface Card BRI S/T (2186)", DESCR: "Wan Interface Card BRI S/T (2186)"
PID: WIC-1B-S/T= , VID: 1.3, SN: 32341361
NAME: "One port E1 voice interface daughtercard", DESCR: "One port E1 voice interface daughtercard"
PID: VWIC-1MFT-E1= , VID: 1.0, SN: 31525479
NAME: "MARs 2 port Voice PM", DESCR: "MARs 2 port Voice PM"
PID: NM-1V= , VID: 1.1, SN: 15648337
NAME: "Two port DID voice interface daughtercard", DESCR: "Two port DID voice interface daughtercard"
PID: VIC-2DID= , VID: 1.0, SN: 32808181
show hardware output
Cisco 2691 (R7000) processor (revision 0.1) with 118784K/12288K bytes of memory.
Processor board ID JMX0642L246
R7000 CPU at 160MHz, Implementation 39, Rev 3.3, 256KB L2 Cache
2 FastEthernet interfaces
1 ISDN Basic Rate interface
1 Channelized E1/PRI port
2 Voice DID interfaces
DRAM configuration is 64 bits wide with parity disabled.
55K bytes of NVRAM.
31296K bytes of ATA System CompactFlash (Read/Write)
0K bytes of ATA Slot0 CompactFlash (Read/Write)
Configuration register is 0x2102
I don't suppose the slot0 is IOS based?
Any suggestions please?
