cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
631
Views
6
Helpful
6
Replies
Highlighted
Beginner

Cfwdall Off-net to Off-net

I am at a loss. I still cannot forward a call off-net from an off-net call. I have checked under service manager, not blocking. Tested multiple CSS settings, everything works as advertised. I can fwd off-net from an internal number fine. What am I missing.

Setup

CUCM 7.1.5

H.323 Gateways.

Thanks in advance

Rich

6 REPLIES 6
Highlighted
Cisco Employee

Hi

Please take a look at the following thread:

https://supportforums.cisco.com/message/3187809

Thanks

Tapan

Highlighted

Thanks for the pointing out.

But, this hasn't resolved my issue.

Highlighted
Hall of Fame Master

Take, "debug isdn q931" with "term mon" and post it here.

Do not take any other debug, do not use attachments.

Highlighted

Below is from my incoming gateway. I have 2, 1 in and 1 out. The outbound gateway doesn't see the call.

632199: *Sep 29 08:36:04.390 ET: ISDN Se0/0/1:23 Q931: RX <- SETUP pd = 8 callref = 0x0237

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9838F

Exclusive, Channel 15

Progress Ind i = 0x8283 - Origination address is non-ISDN

Calling Party Number i = 0x2181, 'XXXXXXXXXX'

Plan:ISDN, Type:National

Called Party Number i = 0x80, '3017'

Plan:Unknown, Type:Unknown

632200: *Sep 29 08:36:04.406 ET: ISDN Se0/0/1:23 Q931: TX -> CALL_PROC pd = 8 callref = 0x8237

Channel ID i = 0xA9838F

Exclusive, Channel 15

632201: *Sep 29 08:36:04.646 ET: ISDN Se0/0/1:23 Q931: TX -> DISCONNECT pd = 8 callref = 0x8237

Cause i = 0x809B - Destination out of order

632202: *Sep 29 08:36:04.686 ET: ISDN Se0/0/1:23 Q931: RX <- RELEASE pd = 8 callref = 0x0237

632203: *Sep 29 08:36:04.690 ET: ISDN Se0/0/1:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x8237

Highlighted

So after posting above I kind of stumbled on what I thought was going on. Seeing as I have 2 gateways I started checking to see if they were talking to each other. Well, my limited knowledge in that didn't come up with anything. So, for a temporary fix, I have created a new CSS, that uses a route pattern, which looks at a reversed ooutbound RG. So when a call comes in my inbound gateway, it gets turned right around and sent out the same gateway. I am going to use this as a temporary fix, but if someone can give me some insight on how to get this working properly I would be greatly appreciative.

Thanks

Rich

Highlighted

Very good, please remember to rate useful posts clicking on the stars below.