Cisco 2801 as gateway and Nortel gatekeeper
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2008 11:27 PM - edited 03-15-2019 11:36 AM
Hi:
I have this scenario, one 2801 with a T1 wic, and one nortel signaling server as gatekeeper, the calls are connect but i don't get audio.
- Labels:
-
Other IP Telephony

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2008 03:43 AM
Can any GW ping any other GW address in your topology ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2008 04:39 AM
yes, currently are communications between the gatekeeper and the cisco gateway. The problem is the audio, i can't hear anything in both ways.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2008 04:41 AM
Hi, GK doesn't take part in media, only signalling.
You need IP connectivity between GWs for a GW/GK setup to work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2008 04:51 AM
i have ip connectivity between my GW and GK.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-28-2008 05:21 AM
Yes, I understood that. The point is that you also need IP connectivity to the other GW that is terminating the call. Unless the GK is actually combined GK/GW.
