Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1947
Views
0
Helpful
1
Replies

Cisco Call manager & Tandberg integration

abhasjain
Level 1
Level 1

‎10-19-2010 10:50 AM - edited ‎03-16-2019 01:26 AM

HI,

I have integrated Tandberg VCS with CUCM 8.0.3 over a SIP  trunk. I am facing below two problems:-

1. When Tandberg phone makes video call to CIsco 9971 phone. The call gets disconnected after about 2 -3 minutes, On CIsco phone call gets disconected & at Tandbeg phone call timer continues but without any video or voice.

2. When Cisco phone makes a call to Tandberg phone a fast busy tone is received.

Please suggest solution for it.

Regards,

AJ

Labels:
0 Helpful
1 Reply 1

Felipe Garrido
Cisco Employee
Cisco Employee

‎10-20-2010 06:38 AM

We'll need either detailed level traces from CUCM or a packet capture of both failures. Reference the following documentation to enable and collect traces.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094e89.shtml

-Felipe

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents