03-19-2015 07:13 AM - edited 03-17-2019 02:23 AM
Hello,
I have an issue with a BRI interface on a CME 2901.
I have 2 MSN numbers on the BRI from the provider. One is 889553 and the other is 886602
I would like my extension 2050 to make outgoing calls only from the 889553 and extension 2048 to make outgoing calls only from 886602.
I can route incoming calls to the extensions successfully.
When somebody calls 889553, the call goes to 2050 and when 886602 the call goes to 2048.
I am interested in the opposite direction. Is it possible to be done??
Thank you
03-19-2015 07:45 AM
You could do this using COR Class Of Restriction. Assign 1 incoming corlist to the ephone-dn and the same corlist as outgoing to the dialpeer pointing to 1 of the BRI ports. Then repeat that with another corlist for the other ephone-dn and BRI port.
03-19-2015 08:03 AM
Thank you for your answer,
but the numbers come on the same BRI from the provider. On interface 0/0/0 on my router i have 3 available numbers (888822, 889553, 886602). Whenever a call is placed from any extension in my network, the number that the provider sends and is seen from the others is 888822.
I do not think it is possible to route calls through the MSN numbers using corlists.
Correct me if i am wrong.
I would like this:
2050 places a call --> call goes out through 889553 and the other participant of the call sees 889553 not 888822
2048 places a call --> call goes out through 886602 and the other participant of the call sees 886602 not 888822.
I have one BRI channel with 3 available numbers.
Thank you
03-19-2015 10:33 AM
You should check translation rules/profiles to modify the ANI as per your requirement.
03-19-2015 01:29 PM
Hello Vivek,
Thank you for your replay.
Can you be more specific with an example configuration
03-19-2015 10:09 PM
Hi,
BRI is not in our region but I believe it's should work in same way as of PRI. Considering the same, you can use following translation rules;
voice translation-rule 1
#rule 1 /2050/ /889553/
#rule 2 /2048/ /886602/
voice translation-profile OUT_ANI
#translate calling 1
Attache the above translation profile to dial-peers as following;
#translation-profile calling OUT_ANI
Thanks
Vivek
03-22-2015 12:46 PM
Thank you for the answer,
i know that on a PRI line it works fine (i have done it in the past).
I tried the above config but still no change..
03-22-2015 09:14 PM
You can get the output of 'debug isdn q.931' to verify the rules are applying correctly and desired ANI is going in setup message.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide