cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1150
Views
0
Helpful
2
Replies

Cisco Unified Communications Manager 8

sem101276
Level 1
Level 1
2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Post more details about the problem you are having, and the exact equipment.

Jonathan Schulenberg
Hall of Fame
Hall of Fame

Also, CUCM does not participate in the audio path and therefore cannot impact echo. There are no settings to control this on an IP Phone although you should verify the problem exists without a headset connected (incorrectly set analog voltage/ohm settings headsets offer to support multiple PBX systems frequently cause this).

All echo cancellation and controls are done on the analog/TDM gateway. Start with this doc:

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a0080149a1f.shtml

Please remember to rate helpful responses and identify helpful or correct answers.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: