Cisco Unified Communications Manager Express Assigning Extension to 7962.

[MYETO]

Good Morning All,

I am trying to register an extension to a phone as it went faulty and needed replacement. 

Both phones were registered before, so here is what I did:

17 wasn't being used and I change the mac address for 12. 

All good for now, however, my Cisco Unified Communications Manager Express does not allow me scroll down to the desired extension as shown bellow. 

I would like to do it through Command Line but I cannot find my way through.

How do you register an extension on a phone through Command Line? 

Thank you in advance for the response. J 

[Jaime Valencia]

Read here:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cmebasic.html

You already have your current configuration for guidance to match against the documentation.

[HARIS_HUSSAIN]

That is simple just add button command in ephone 12. Say you want to configure Ext 205 i.e dn number 19 on this phone. so just add below

ephone 12
mac XXXX.XXXX.XXXX
button 1:19


*** Please rate helpful post; Mark "Accept as a Solution" if applicable

Thanks,
Haris