CME 10.5 SIP - BLF on 881V Router

[peraocompany]

Hello everyone. I try configure BLF for Cisco SIP phone on CME 10.5. And in not working. Can BLF function (for SIP) supported on 881V platform? Best Regards.

[R0g22]

What phones do you have and what does the config look like ?

[peraocompany]

Hello Nipun, thank you.

I have Cisco Dx-650 and Jabber for Windows.

Global "presence" comand not work in CLI.

voice register global
 mode  cme
 source-address 192.168.x.x port 5060
 max-dn 19
 max-pool 5
 authenticate register
 authenticate realm all
 voicemail 0001160
 phone-mode phone-only
 tftp-path flash:
 create profile sync 0059692231081353
 network-locale RU
 user-locale RU
!
voice register dn  1
 number 0001341
 allow watch
 name Alex
 no-reg
 label Alex
 mwi
!
!
voice register dn  4
 number 0003003
 allow watch
 name Jabber
 no-reg
 label Jabber
 mwi
!
voice register template  1
 phone-mode phone-only
!
voice register pool  1
 id mac xxxx.xxxx.xxxx
 type DX650
 number 1 dn 1
 presence call-list
 dtmf-relay rtp-nte
 voice-class codec 1
 username 000xxxx password xxxx
 camera
 video
 blf-speed-dial 4 0003003 label "Jabber" device
!
!
voice register pool  3
 id device-id-name Jaber
 type Jabber-CSF-Client
 number 1 dn 4
 template 1
 presence call-list
 username xxxx password xxxx
 codec g711ulaw
 phone-mode phone-only
 camera
 video

sip-ua
 presence enable

[R0g22]

Can you remove the "device" keyword from the BLF SD config, recreate the profile and then reset ? Let me know the status post that.
If it does not work, send me output for

show presence global
show presence subscription summary

[peraocompany]

I also try without "Device". Situation is not change.

GW#show presence global
                 ^
% Invalid input detected at '^' marker.

GW#show presence subscription summary
                 ^
% Invalid input detected at '^' marker.

[R0g22 · Accepted solution]

I just checked. BLF is not supported on 881 Platform.

[peraocompany]

Thank you!