CME 8.5 - CTI RP equivilent?

[sjones@techsgi.com]

Hello--i'm trying to figure out an equivilent to a CTI route point for CME.  I've got a client who has their existing PBX interconnected across a MAN to a CME system at a remote site, and in order to route calls to a particular number, i need the functionality of a CTI RP to act as a virtual phone so that a DN becomes active.  Has anyone done something similar?

Scott J.

[paolo bevilacqua]

Just configure dial-peer appropriately, sometime need to do number manipulation. That's all.

[sjones@techsgi.com]

Appreciate the info Paolo.  I've actually been trying that and the issue i'm running into is i get an ISDN 'no route to number' message and an error tone.  topology looks like this:

Avaya PBX --> C2901 router via PRI --> C2921 CME router via IP network

I can call the physical IP phones with no problem...not sure if it's some sort of codec issue or something?

Let me know and i can send the config to you via PM

thanks again.

SJ

[paolo bevilacqua]

One would need to look at relevant traces to see what's wrong.