CME- Dial out problem with corlist

[amanyelukar]

Hi All;

I have CME configured with cor. I have two dial-peer one for International access and other for national access as shown below.

**International access**

dial-peer voice 21 pots

corlist outgoing International

preference 2

paramspace callsetup after-hours-exempt TRUE

destination-pattern 8.T

incoming called-number .

direct-inward-dial

port 0/0/0:15

other one is

** Nationla access***

dial-peer voice 20 pots

corlist outgoing National

preference 1

destination-pattern 9.[1-9]T

incoming called-number .

direct-inward-dial

port 0/0/0:15

Most of the things works fine axcept the national numbers not internation with second digit zero (0) like i 6054532 and 9054532, 802066. I ma using 9 to dial out and to dial international i am using 8 to dial out. In pots dial-peer voice 20 i have destibation pattern 9.[1-9]T for national calls.I dont know how router CME blocking only calls with second digit zero not including 9 to dial out. rest is working fine.

waiting for your reply.

[paolo bevilacqua]

Hi,

try making you DP more specific and the problem should go away. eg:

dial-peer voice 21 pots

destination-pattern 900[1-9]......T

prefix 00

dial-peer voice 20 pots

destination-pattern 9[x-y]....T

replace x and y above with the valid range of digits for national calls. In the example 9 is used for all calls, as for COR to work is not necessary that you use separate digits.