CME Dial Plan Issues

[reb-gun3000]

Hello,

CME with a request not to have to dial 9 for an outside line.  The issue we are facing is that the Telco is sending 1212 down the PRI for a DID that we translate into a 3 digit DN.  Since users do not have to dial 9 to get an outside line whenever they try to dial NYC at 1(212)xxx.xxxx the router sees 1212 and tries to send it back down to the DN.

Can anyone tell me a way to work aroud this?  I tried to add a specific dial-peer for 1212 (perhaps I did it wrong) but that did not seem to help.

Thanks in advance.  Replies rated.              

[Harmit Singh]

Hi there,

Could you share the running config please? Also, please replicate the issue and capture "debug voip ccapi inout".

Regards,

Harmit.

[Chris Deren]

If you are doing the translation via translation rules which are applied to proper voice port or dial-peer you should not have any overlaps here. If you are using num-exp or dialplan pattern you will run into the issue you are describing. Please post full config as asked by Harmit.

HTH,

Chris

[reb-gun3000]

Thanks for ther responses,

The DN was actually for a MeetMe.  As it turns out I still had a few of the 1212 existing as a secondary DN on the MeetMe ephones.  Once I got rid of them call flow returned to normal.

Thanks for the replies!!