CME gets busy signal when I dial out

[mercdecember]

For some rason my current config works, but if I were to just add the statement

conf t

voice translation-rule 3

end

The rule is applied to nothing and has nothing applied to it I get busy signal, if I do:

conf t

no voice translation-rule 3

end

I still get a busy signal.

If I do not save my config and reboot, I can make a cal when my router comes back online.

attached is my config please let me know what if there is something wrong with it or if there is something I need to apply.

My router is a 2800 series router

[Niranjan Durairaj]

Hi,

Please send "debug ccsip messages" & "debug voip ccapi inout" outputs.

Thanks,

Niran

[mercdecember]

Attached is the output

[Chintan Gajjar]

Hi,

I can see that you are getting  404 from your sip provider.

Received:
SIP/2.0 404 Not Found
Via: SIP/2.0/UDP 50.0.0.21:5060;branch=z9hG4bK281446;received=50.0.0.21;rport=10                                                                                        38
From: <sip:9142281462@newyork.voip.ms>;tag=CEECC-1D72
To: <sip:18042221111@newyork.voip.ms>;tag=as295cc05e
Call-ID: A424B755-2DEC11E4-802FF15A-3687DBF8@50.0.0.21
CSeq: 101 INVITE
Server: voip.ms
Allow: INVITE, ACK, CANCEL, OPTIONS, BYE, REFER, SUBSCRIBE, NOTIFY, INFO, PUBLIS                                                                                        H
Supported: replaces, timer
Content-Length: 0

can you try changing your destination pattern

for 

91[2-9].........

to

9[2-9].........

and check if its working, just give a try and see if it works.

regards

Chintan

[mercdecember]

I can try this tonight, but what does not make sense to me is it works until I create a voice translation rule.  Then after that I need to reboot my router for calls to work and I do not save the config. 

[mercdecember]

Both 10 and 11 digit dialing are working, it appears everything works after I reboot the router after I make really any changes to CME.  Is there anything I can do to not have to reboot this router everytime I run into this issue?