CME Media Resource Configuration?

[MehmetKaya]

Hi All,

I have a 39XX router as cme and cue (40 phone regiter it). That router is just connected to PSTN. So At this point I think that I dont have to make media resource configuration like blow. am I right ? or Which configuration should I make. I will just using voice not video. And If I dont make media resource configuration how my media resource will be concumed?

voice-card 0

no dspfarm

!

voice-card 1

no dspfarm

dsp services dspfarm

!

sccp local GigabitEthernet0/0

sccp ccm 10.15.15.1 identifier 1 version 4.1

!

!

sccp ccm group 1

associate ccm 1 priority 1

associate profile 101 register confer1

associate profile 103 register xcode1

!

!

dspfarm profile 103 transcode

codec g711ulaw

codec g711alaw

codec g729r8

maximum sessions 6

associate application SCCP

!

dspfarm profile 101 conference

codec g711ulaw

codec g711alaw

codec g729r8

maximum sessions 5

associate application SCCP

[Chris Deren]

What media are you referring to?

Your config is for transcoders, but do you need them?

And hardware conference bridges which are nice to have as software CME bridges only allow 3 participants.

Chris

Sent from Cisco Technical Support iPhone App

[gpsriramdc]

Hi ,

Transcoding is not required if you only going to connect with PSTN . You can define the conference resource based on the no of attendes in the conference.

If you want more than 3 participants in the conference you require Hardware Confernce ( dspfarm Profile) required

Thanks

[ronpatel]

Hi,

You do not need media resource if you only need normal PSTN calls. Media resoutce are required when you want

conference, transcode  or mtp ( Media Termination point ).

regards

Ronak Patel

Rate helpful posts.