CME with PBX

kashif2401 · ‎02-20-2017

Hello

I would like to to connect our Cisco CME 2911 router 15.5 IOS, to be able to call our other building using traditional PBX system, i have FXS and FXO card already installed on the CME router, how do i go about this?

please, i need a guide and how i will configure it to work ASAP.

Mohammed al Baqari · ‎02-20-2017

This guide should be very good for you to start.

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unity-express/62609-tdcmecue.html

kashif2401 · ‎02-20-2017

Hi Mohammed,

I know how to setup IP telephony, what i need is a guide to integrate a pbx with cme, so that IP Phones registered with cme can communicate with analog phones connected to PBX system which is in another building

Mohammed al Baqari · ‎02-21-2017

Hi,

The document which I provided include this as well. Basically you need to configure analog dialpeers out of your FXO ports

kashif2401 · ‎02-21-2017

Can someone show me the connectivity

Right now i have this, and all hardware is on remote side..

IP Phones-->HQ CME Router---> SiteB Router---Fxo and Fxs---> PBX---> Analog Phones

lets say analog phones have extns 3xxx and ip phones have 2xxx

On site B Rtr:

dp 1 voip

dest-pat 2xxx

sess target 10.1.1.1 (HQ)

dp 2 pots

dest-pat 3xxx

port 0/1/0 (FXS)

is it correct? or it needs any more config.

Please help

Jaime Valencia · ‎02-21-2017

That will depend on what the other side has to trunk, if it supports SIP/H.323, configure the dial peers pointing to it.

If it requires TDM, then connect the two systems and configure your TDM.

HTH

java

if this helps, please rate

kashif2401 · ‎02-21-2017