Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I'm looking for a little assistance with configuration of 8831/41/51 phones on a new CME implementation I am working on. The phones are configured using the fast track method, and are requesting configuration files, but the CME seems unable to locat...
I have call manager 10.5. I would like to see how many calls a specific number received for a set time frame. how would I generate a report to show me the calls for a specific number? for instance number xxx-xxx-xxxx received yy number of calls betwe...
I recently got a request to change my call forward all settings so that the forwarded call appears on the last device with the first number that dialed. I can't quite figure out how to do it, and have been unsuccessful in finding good documentation o...
Dear All, I have 400 phones already registered with cucm. My requirement is to subscribe these phones with extension mobility service using BAT. I have referred the below link but it is not very clear to me. Can this be achieved without removing phon...
Hello everyone, I would like to know if there's a method to seach all available extension number of a determined CSS. I need to get a report of all the extensions that can make international calls. Thanks in advance.
Dear Gents, As part of CUCM migration we moved few Video endpoints to registered in CUCM along with Expressway pairs which is used for B2B calls. Apart from that in our existing environment we use separate Video conferencing , Some of Endpoints are ...
Hi, The scenario here is that the CUBE makes an outbound call, receives either 180 or 183 with SDP indicating that the ITSP should be sending RTP carrying the appropriate tones or message. At this stage some ITSPs expect that the called party (CUBE...
Hello Guys, at the moment I have a problem with setting up calls from an analog device connected to an ATA187 to other IP phones or external devices. The analog phone can be called from internal and external but if i try to setup a call from the ana...
Can I check phone installed date on CUCM? Thanks, Rajitha
Hello,Attempting to use the BAT Excel Spreadsheet 8.x on Windows 7 and Office 2010 all 64-bit and recieving the following error:``Compile Error: The code in this project must be updated for use on 64-bit systems....``Has anyone found a way around thi...
I have one site where some ip phones are connected with our main cucm. But rest of the phones are created at local cucme (router 2951). Is it possible that 5 phones connected with CUCM can reach to local created phones???
We have a CM 10.6 and we are running into issues with identifying where a DN has been programmed onto another device as a busy lamp. It doesn't show up when looking at dependencies. Where can we find it without much work. Is it possible?
Hi, Just wanna know the translation pattern for below scenario: We have DID numbers of 23855XXX and 2399XXXX, I programmed one extension 55100 for one user on his telephone.If he dial any private number(PSTN) or any mobile number to outside, the numb...
Hello All. We Already Using Cisco 8851 IP Phone with Key Extension Module which works fine, now we buy two new Cisco 8851 IP Phone with Key Extension Module and i am trying to configure the same like previous configuration done by another engineer bu...
Hi all, Was running into a peculiar issue today while trying load new DX80 code into the CUCM using an FTP install process. The CUCM kept coming back after I've selected the file I want to download telling me that the file is inaccessible and to ch...
