conditional dial-peer for SRST

[ilyas.safarov]

Hi everyone,

Is it possible to use conditional dial-peer for SRST?

For example , I've a router via MGCP registered to CUCM. The router have 3 E1 cards and in normal circumstances they are used by 3 different device pools in CUCM. But what if all phones falls to SRST ,how can i use these 3 E1 cards in the same manner?

Thanks 

Ilyas

[Jaime Valencia]

If you're using only MGCP in the GW, the call routing would only use the dial-peers when you go into SRST mode, then you need to configure the routing as you need with the inbound and outbound dial-peers.

[ilyas.safarov]

Thank you for reply Jaime.

I am aware about it. I just want to know , how to force router to send calls lets say for x range numbers via first e1, for y range via second e1 and for z range via third e1

Thanks

Ilyas

[Jaime Valencia · Accepted solution]

You can try COR with SRST