Config setup with Call manager 6.14 and a internal paging system

[D0nprintup_2]

Hi

I am running call manager 6.14 and we have a third party paging system getting installed. Now it connects to our IPT system via FXS and FXO ports, The paging system is a digital system and has different zones. Now there is an extension for each department but within that department there are zones.

Extension to call is 1000

zone 01 = warehouse

zone 02 = warehouse offices

zone 03 = both

So when a call is placed to 1000, its going to the warehouse paging system. When you dial 1000, one sec later you hear dead air and then you need to dial 01 or 02 or 03 depending on who you want to page.

My question is, is there a way to setup the system to do this

If i call 1000, it rings and connects, then it automatically dials 01 or want ever one i want it to default too.

[Jaime Valencia]

No way to do such thing, CUCM has no way to insert a pause in a dial string.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[D0nprintup_2]

could i do somehing like a pause dial with route patterns?

[Jaime Valencia]

No, there is no representation of a pause in CUCM anywhere.

If you're using H323 GWs reach Paolo (look leaderboard) as he has a script that can do this.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[D0nprintup_2]

In CME you can put a comma in a translation rule and it will put a pause and then continue

translation-profile 1800
rule 1 /1800123456789/ /1800123456789,4321/

This same thing cannot be done in the full blown call manager?

[Jaime Valencia]

No, as I already mentioned, CUCM has no representation of a pause for any dial pattern.

Simply put, CUCM has no pauses. It sends the whole dial string.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk